LaboratoryEquipment.caCasework · Fume hoods · Cleanrooms Placeholder data
Materials · Worktop

Epoxy resin worktops

Epoxy resin lab worktops explained, covering how they are cast, their chemical and heat resistance, weight and chipping limits, and care.

Epoxy resin has been the default worktop for wet chemistry labs for decades. It is cast as one solid material, resists a wide range of chemicals and tolerates more heat than most other non-metal worktops. Its main drawbacks are weight and brittleness under sharp impact.

How it is made

Epoxy resin, a hardener and inert fillers, mainly silica, are mixed and poured into molds, then cured, often with heat, into a dense slab. The material is the same all the way through, so a scratch exposes more of the same surface rather than a different core. Common thicknesses are 25 mm (1 in) and 19 mm (¾ in).

Because it is cast, epoxy can be molded with raised marine edges, drip grooves and integral sinks. Our sink base uses a molded epoxy sink for this reason, and epoxy is also used for pegboard drying racks.

Performance

Chemicals. Epoxy resists most acids, bases, salts and organic solvents used in labs. Concentrated oxidizing acids can stain or etch it, and hydrofluoric acid attacks the silica filler. Check the maker's resistance chart against your own chemical list.

Heat. Epoxy tolerates more heat than phenolic resin, which is why it is common on fume hood work surfaces. Sudden, concentrated heat can still crack it, so hot plates, burners and hot glassware should sit on a heat-resistant pad or trivet.

Moisture. Non-porous and unaffected by water, which makes it a strong choice around sinks. See our guide to lab sinks and drainage.

Impact. Epoxy is hard but brittle. A heavy object dropped on an edge can chip it. It is also heavy, so it needs solid support from base cabinets or a rigid frame.

Where it suits

  • Wet chemistry, analytical and organic synthesis labs
  • Fume hood work surfaces, especially dished tops that contain spills
  • Sink runs and areas with frequent water use
  • Teaching chemistry labs with mixed chemical exposure

Where it does not

  • Mobile tables and adaptable benches that move often, where its weight is a burden
  • High-impact areas such as workshops
  • Hydrofluoric acid work
  • Cleanrooms and radioisotope labs, where seamless stainless steel 316 is easier to decontaminate

Comparison

PropertyEpoxy resinPhenolic resinStainless 316
Chemical rangeVery broadBroadBroad, weak to chlorides
HeatGoodFairExcellent
ImpactCan chipGoodDents, does not crack
WeightHeavyLighterModerate
RepairSand and polishLimitedPolish out scratches

For a side-by-side discussion, see epoxy vs phenolic worktops and the phenolic resin worktop page.

Care and cleaning

  • Clean with mild detergent and water and rinse well.
  • Wipe up concentrated acids and oxidizers promptly.
  • Avoid abrasive pads for daily cleaning; they dull the finish.
  • Light scratches can be sanded and buffed. Some makers recommend a periodic polish to restore the sheen.
  • Check seams and sink joints and reseal if needed.