Stainless steel is the worktop of choice where surfaces must be sterilized, decontaminated or exposed to heat and water every day. Type 316 is used for worktops because it resists chlorides and pitting better than the more common 304.
What it is and how it is made
Type 316 is an austenitic stainless steel with chromium, nickel and roughly 2 to 3% molybdenum. The molybdenum strengthens the protective oxide layer against chlorides, which are found in bleach, salt solutions and many disinfectants.
Worktops are formed from stainless sheet. The top is usually bonded to a rigid core or reinforced with welded channels underneath, with sound-deadening on the underside. Sinks can be welded in to make one continuous surface. Raised marine edges and coved backsplashes keep spills on the top and leave no seams for contamination to collect. A coved work surface is standard in radioisotope hoods for the same reason. The usual finish is brushed No. 4.
Performance
Heat. Excellent. Stainless takes hot plates, burners and hot glassware without damage.
Moisture. Excellent. Water, steam and wet cleaning do not affect it.
Decontamination. Non-porous, seamless stainless is the easiest worktop to clean and decontaminate, which is why it is used for radioisotope, sterile and containment work.
Chemicals. Stainless resists most solvents, bases and many acids. Hydrochloric acid, hydrofluoric acid, hot concentrated chlorides and some halogen compounds attack it, even in grade 316.
Impact. Stainless does not crack or chip, but it can dent, and scratches stay visible.
| Exposure | How 316 performs |
|---|---|
| Heat and flame | Very good |
| Water and steam | Very good |
| Alcohol and peroxide disinfectants | Very good |
| Bleach and chloride solutions | Fair, rinse after use |
| Hydrochloric and hydrofluoric acid | Poor |
Where it suits
- Cleanrooms and pharmacy compounding rooms
- Radioisotope labs, including hoods such as our radioisotope fume hood
- Microbiology and cell culture labs with frequent disinfection
- Food testing labs and wet process areas
- Glasswash and autoclave rooms
Where it does not
- Acid digestion and chemistry using hydrochloric acid, where epoxy resin or a PVC-lined hood is a better fit
- Budget-driven dry labs, where phenolic does the job at lower cost
- Rooms where noise from set-down glassware or glare under bright lighting is a concern
Our guide to choosing a lab worktop compares stainless with epoxy and phenolic for each type of exposure. For cleanrooms, see cleanroom furniture and stainless steel.
Care and cleaning
- Clean with mild detergent and water, wiping along the grain.
- Rinse with clean water after bleach or chloride disinfectants, then dry.
- Never use steel wool or carbon steel brushes, which leave iron particles that rust.
- Use a stainless cleaner for tea staining or fingerprints.
- Ask about passivation if rust spots keep returning.
Stainless worktops often sit on stainless 304 casework in cleanrooms and wet areas.