LaboratoryEquipment.caCasework · Fume hoods · Cleanrooms Placeholder data
Materials · Finish

Painted steel casework

How powder-coated steel lab casework is made, how it handles chemicals, moisture and impact, where it fits best and how to look after it.

Painted steel is the most common choice for lab casework. It is strong, non-combustible, easy to clean and suits most chemistry, biology and teaching labs. Its protection comes from the coating, so its performance depends on keeping that coating intact.

How it is made

Cabinet bodies, doors and drawers are formed from cold-rolled steel sheet, then welded or fastened into a rigid box. The steel is cleaned and given a conversion pretreatment so the coating bonds well. A chemical-resistant powder coat, usually epoxy or a hybrid of epoxy and polyester, is applied electrostatically and baked to cure into a hard, continuous film.

Metal casework is covered by SEFA 8M, which sets out construction and test methods for load, durability and finish resistance. Our guide to SEFA 8 casework standards explains what those tests mean and how to ask a supplier about them. In the planner, painted steel comes in two finishes: Arctic white and Slate blue.

Performance

Chemicals. A good powder coat resists splashes of most common acids, bases and solvents when they are wiped up promptly. Long contact with strong solvents or concentrated acids can soften or stain it.

Moisture. The coating seals the steel, but a chip or deep scratch lets moisture reach bare metal, and rust can then creep under the film. Sink bases and the lower edges of doors are the usual problem spots.

Impact and load. Steel casework is strong. Drawers carry heavy loads and cabinets support epoxy worktops without sagging. Hard knocks dent the steel rather than break it, though a dent can crack the coating.

Heat and fire. Steel does not burn. Casework is not a heat-bearing surface, but normal room temperatures and warm equipment pose no problem.

Where it suits

  • General chemistry, analytical, QC and teaching labs
  • Hospital and clinical labs with routine disinfection
  • Fume hood base cabinets for general storage
  • Labs that need high drawer loads or heavy worktops

Where it does not

  • Constantly wet rooms such as glasswash and cage wash, where solid phenolic or stainless performs better
  • Rooms with heavy acid vapor, such as acid digestion areas
  • Cleanrooms and containment suites that use harsh sporicides daily, where stainless steel 304 casework is the usual choice

Comparison with other casework

FinishMoistureChemical splashImpactTypical fit
Painted steelGood if coating intactGoodVery goodMost labs
Solid phenolicExcellentVery goodGoodWet and corrosive areas
Maple veneerFairFair to goodFair, repairableDry and teaching labs
Stainless 304ExcellentGood, not chloridesVery goodCleanrooms, wet, sterile

Our guide to steel, wood or phenolic casework goes deeper on the trade-offs.

Care and cleaning

  • Clean with mild detergent and water and a soft cloth, then dry.
  • Wipe chemical spills as soon as they happen.
  • Avoid abrasive pads and scouring powders, which wear the coating.
  • Touch up chips and scratches with matching paint before rust starts.
  • Check sink bases regularly for leaks and standing water.

Our cleaning and care guide covers disinfectants and stain removal in more detail. To see painted steel in a layout, browse the base cabinet range.